Preferences - Daily Summary Emails Panel

As the System Administrator, you can choose to receive a single, daily email report that summarizes all of the backup activity for your Backup for Workgroups users. To do so, check/tick the Generate one email report per day option. Use the Daily Summary Emails panel to specify when you want to generate this report and the email addressing details that should be used to send this report. Please note that the Daily Summary Reports are sent in HTML format only. To view these reports, you need to use an Email Client that can display HTML email.

If you are having a problem receiving your daily email summary messages, please read the Troubleshooting section below.


Troubleshooting common problems experienced when trying to send email:

  1. Backup for Workgroups Cannot Connect to Your Email Server.

    A.   Firewall Restrictions, Port Blockers, Virus Checkers/Worm Stoppers - These devices or programs prohibit outbound SMTP (Port 25) network access.  It is very common for most virus checkers to block email generation.  Also, some firewalls block outbound STMP email.  If you have a virus checker, a firewall, or any other port blocker running, you will need to enter an exception into these programs for Backup for Workgroups.  In order to implement the exception, you will need to follow the instructions provided by the manufacturer of the firewall, port blocker, or virus checking program.  The exception should be configured to allow the Backup for Workgroups Service called "BackupService.exe" for 32 bit versions of Windows and ""BackupServiceX64.exe" for 64 bit versions of Windows.  Once the exception is in place, Backup for Workgroups can send email.

    B.  Relay Restriction - By default, Microsoft Exchange Server has a setting to deny relaying.  Too many spammers were finding open Exchange Servers to forward their email through to hide their identity, so Microsoft changed the default to not allow email to be transferred through the Exchange Server unless the sending is approved.  To add the Backup Server to the Microsoft Exchange Server approved relay list, perform the following:

    1.  Open the MS Exchange System Manager.
    2.  In the left hand panel, expand "Servers", then expand the name of your email server, the expand "Protocols", then expand "SMTP".
    3.  Under the SMTP protocol will be an item labeled "Default Virtual SMTP Server". Right-click on this and choose "Properties".
    4.  On the Properties dialog, switch tabs to the "Access" tab, and select the button labeled "Relay".
    5.  On the "Relay Restrictions" dialog, press the "Add" button.
    6.  Enter the IP address of the machine running the Backup for Workgroups Backup Server software.  This will grant Backup for Workgroups the right to send email to your Exchange Server.
     

  2. Email Server Refuses to Accept Email Messages from Backup for Workgroups.

    The most common cause of email rejection occurs when either the FROM: or TO: email address is not present in the list of known email addresses within your email server.  In other words, email is commonly rejected because the email server does not recognize either the FROM: email address or the TO: email address.

    By default, Backup for Workgroups sets the FROM: email address to read as "BackupForWorkgroups@YourDomain.Com", where YourDomain.Com is replaced with the TO: email address.  If your email server checks the FROM: email address, it may reject the email because it probably does not have a user named BackupForWorkgroups.  To solve this, you can do one of two things.  You can choose to add a user with the name BackupForWorkgroups to your email server's list of approved users.  Or, you can change the FROM: address that Backup for Workgroups uses.  To change the FROM: email address used by Backup For Workgroups, use the Daily Summary Emails or Backup Run Emails tabs available from the Preferences Panel.